SPC UV MARBLE WALL

It is recommended to always install the floor in the direction of the smallest side of the room.

•It is important to decide the modulation before starting assembly. Make sure that the notches between zones are not less than 30 cm.

• Lay the boards on the subfloor and fit them gently, from left to right, with the female side facing the wall. We recommend always maintaining a distance of 2 to 3 mm from the wall.

•Position the plank to be installed at an angle of 15° to 20° with respect to the plank already installed, until the union between both is perfect.

•One of the best attributes of spc vinyl plank is that it allows you to make corrections if the fit is not correct, just remove the plank, disassemble it and reassemble it.

•When you reach the other end of the wall, cut the strip ensuring a
minimum separation of 2-3mm.

•Always use the professional cutter with the help of a ruler to ensure a perfect cut. Pass the cutter gently, but firmly. Chalk line go deeper into the cut to form a slit. Then press lightly to break the ruler at the slit line. We advise keeping the cut pieces, they may be useful in other areas.

•Use gentle pressure on all the joints to ensure the correct closure of the fittings, leaving the boards perfectly joined.